Aviator-Pro 40 Almost-Ready-to-Fly Instruction Manual Specifications Wingspan: 68.5 in (1740mm) Length: 46.4 in (1180mm) Wing Area: 610.7sq in (39.
www.valuehobby.com 10 Step4. Position the elevator against the stabilizer on the work surface; Use a felt-tipped pen to mark the position where the
www.valuehobby.com 11 Step10. Once the requirements satisfied in step9, apply thin CA on both the top and bottom of the stabilizer to secure the sta
www.valuehobby.com 12 Step7. Glue the hinges into the slots in the rudder. Test fit the tail gear wire into the rudder, and use the epoxy to secure
www.valuehobby.com 13 Step4. Thread the clevis a min of 10 turns on the pushrod wire. Connect the clevis to the control horn. (In this step you can
www.valuehobby.com 14 Section 7: Nitro Motor Installation Step1. Locate the necessary parts for this section. Skip this section if you are using an
www.valuehobby.com 15 Section 8: Fuel Tank Installation Step1. Skip this section if you are using an electric motor. The fuel tank can be assembled
www.valuehobby.com 16 Section 9: Electric Motor Installation Step1. Secure the motor box to the firewall. Step2. Install your brushless motor o
www.valuehobby.com 17 Section 11: Landing Gear & Wheels Installation Step1. Secure the axle to the landing gear using pliers and hex wrench.
www.valuehobby.com 18 Section 12: Canopy installation Locate the required parts and trim the edges of the canopy as needed. Use four screws to secu
www.valuehobby.com 19 Finally... Enjoy Your Aviator-Pro 40 ARF Have a nice flight!
www.valuehobby.com 2 Dear Customer, Congratulations on your purchase of Aviator-Pro 40 ARF from Value Hobby. We thank you for your generous support
www.valuehobby.com 3 Safety in Flying This is NOT a toy! It is a very high-performance RC airplane capable of high speeds and extreme maneuvers. It
www.valuehobby.com 4 RECOMMENDED RADIO EQUIPMENT: Product SKU Quantity Radio 6 Channel FLY-RC-1310 1 Servo Towerpro MG996R Standard Servo TWP-S
www.valuehobby.com 5 Main Parts of the Airplane
Section 1: Aileron Installation Step1. Locate the aileron hinges from the hardware pack, and insert the hinges in the slots in the trailing edge of t
www.valuehobby.com 7 Step4. Position the servo on the servo hatch, and the servo arm should be centered in the slot. Once satisfied, use a felt-tipp
www.valuehobby.com 8 Step10. Use four self-tapping screws to install the servo hatch to the wing. (Note: in this step, first you need to drill the h
www.valuehobby.com 9 Step3. Make sure the wing panels fit tightly. When the epoxy cured, position the wing bolt plate on the wing, aligning the hole
Kommentare zu diesen Handbüchern